| Welcome to Altezza Club Of NZ/Australia. We hope you enjoy your visit. You're currently viewing our forum as a guest. This means you are limited to certain areas of the board and there are some features you can't use. If you join our community, you'll be able to access member-only sections, and use many member-only features such as customizing your profile, sending personal messages, and voting in polls. Registration is simple, fast, and completely free. http://s4.zetaboards.com/lexusaltezzaclub/topic/1148393/1/#new |
| Mid Section Exhaust; vs crowbar | |
|---|---|
| Tweet Topic Started: Feb 25 2012, 06:53 PM (531 Views) | |
| tuiman | Feb 25 2012, 06:53 PM Post #1 |
|
Stock
![]() ![]() ![]() ![]()
|
Hey guys i won a mid section exhaust off trade me for a $1 for my 3sget. I was thinking of using a crow bar and stab a hole right threw the resonator just to make my exhaust more free flowing. Would this be algood for my turbo setup has anyone tried stabing a hole right threw theres or taken it out. Cheers |
![]() |
|
| greeneyes | Feb 26 2012, 09:37 AM Post #2 |
|
Targa Master
![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]()
|
Take a look inside one first.. The local garage has a couple of bits of catalytic honeycomb on the counter, they are long sections of very fine hollow hexagons, they look like charcoaled wood. That one had broken up inside the resonator and after 5minutes of driving the car would lose power and die as the pieces of honeycomb piled up against the exit pipe.. After a few minutes it would start and drive again, then stop after 5minutes.. You might have to make sure you don't break up the structure and leave pieces to block it up. |
|
The Girl's KE70- http://www.rollaclub.com/board/topic/42407-the-girls-ke70/ How NOT to build a rally car- http://www.rollaclub.com/board/topic/64027...ld-a-rally-car/ | |
![]() |
|
| 1 user reading this topic (1 Guest and 0 Anonymous) | |
| « Previous Topic · Engines • Intakes • Exhausts · Next Topic » |





![]](http://z4.ifrm.com/static/1/pip_r.png)



8:51 PM Jul 11